the testforblock command in a command block will check for a block in a certain position. Otherwise, you can check for if a player has placed that block anywhere, look for SethBling’s video clippy in minecraft for that. the testforblock command in a command block will check for a block in a certain position.
How do you find a specific block in Minecraft with commands?
How to get a Command Block
- Enable cheats in your world or Realm settings.
- Turn on Creative Mode in your world or Realm settings.
- Open the chat box and enter “/give [your username] command_block”
- Place the block where you want it.
How do you find the radius of a block?
Sadly there is no way to run a testforblock in a radius, the best you could do is run several testforblock commands at all the block locations within the 5 block radius. A method to test for a block around the player is to use /fill commands alongside CommandStats.
How to detect players in certain area using command blocks?
If you would like to detect players in a radius around a certain coordinate, instead of a radius around the the command block, you can use a command like this: /testfor @a [x=X,y=Y,z=Z,r=RADIUS] To make this a bit clearer, the X, Y, and Z in the command are the center coordinates of where the command block will test for players.
How do you setblock a block in Minecraft?
Press the Enter key to run the command. This /setblock command would replace the block at ~1 ~0 ~1 with a birch plank. This is the block that is 1 block East, 0 blocks downward, and 1 block South of where the command is run.
What’s the range of a command block in Minecraft?
Range 2 is the range a player want for a command block under a floor. Keep in mind that it will produce a globe shaped trigger area (rather than a cube), so a range of 2 makes an approximately 5×5×5 area and a range of 1 makes a 3×3×3 area (more like a + pattern with an extra block above and below the center).
What is the function of the EXECUTE BLOCK in Minecraft?
This allows the player to destroy a cube of materials around them as they walk, using / execute. The command is / execute as @p at @s run fill ~1 ~2 ~1 ~-1 ~0 ~-1 air. Use the repeating command block with the “Always Active” option selected, and the cube of air will be created wherever a player go.
